Skip to content
Crypto.world

The Ledger

LlamaRisk recommends Aave V4 rate increases and higher equity caps

LlamaRisk recommends raising interest-rate slopes on five Aave V4 reserves and increasing add caps for two tokenized-equity assets. The proposed changes include a 45,000 cap for NVDAc and a 20,000 cap for METAc on Base.

LlamaRisk recommends Aave V4 rate increases and higher equity caps

Rate changes proposed across five reserves

LlamaRisk, a risk service provider funded in part by the Aave DAO, recommends higher interest-rate slopes on five Aave V4 reserves and larger add caps for two tokenized-equity assets on Base, according to its Nov. 18 post. The recommendations cover Ethereum, Avalanche and Base and are based on LlamaRisk’s review of reserve use, on-chain liquidity and position health.

For Ethereum’s Core Hub, LlamaRisk proposes raising the slope1 parameter for frxUSD from 4.00% to 4.25% and for USDT from 4.50% to 4.60%. On Ethereum’s Plus Hub, it recommends moving the USDT and USDC slope1 values from 4.70% to 4.80%. The proposed Avalanche change raises USDC’s Core Hub slope1 from 4.50% to 4.60%.

Borrow rates and reserve debt

LlamaRisk’s table sets out current and proposed borrow APRs alongside utilization for each reserve. For Ethereum Core frxUSD, it lists utilization at 89.9%, an optimal usage ratio of 90.0%, and a rate change from 4.00% to 4.25%. Ethereum Core USDT is at 90.0% utilization against a 92.0% optimal ratio, with the listed APR moving from 4.40% to 4.50%.

Ethereum Plus USDT is listed at 92.0% utilization, with its borrow APR rising from 4.70% to 4.80%; Plus Hub USDC is at 84.4% utilization, with a proposed move from 4.31% to 4.40%. For Avalanche Core USDC, the table shows 91.2% utilization and a proposed APR increase from 6.80% to 6.90%. As of Nov. 18, the five reserves had approximately 58.0M in aggregate debt, most of it in USDT and frxUSD on Ethereum Core, according to LlamaRisk.

The provider says the base rate, optimal usage ratio and slope2 would remain unchanged for every reserve. Under the proposed parameters, at or above the optimal usage ratio, the borrow rate would rise by the full slope1 change.

Higher add caps for NVDAc and METAc

On Base’s Equities Hub MAG7 Spoke, LlamaRisk recommends increasing NVDAc’s add cap from 35,000 to 45,000 and METAc’s from 10,000 to 20,000. The post lists NVDAc’s existing cap as 69.2% utilized on Nov. 18, or 24,216 of 35,000; the proposed cap would put utilization at approximately 53.8%.

METAc’s existing add cap was 58.1% utilized, or 5,810 of 10,000, according to the same review. LlamaRisk estimates that a 20,000 cap would bring post-change utilization to approximately 29.1%.

The provider also reports concentrated supply in both markets. On the MAG7 Spoke, the largest NVDAc position held approximately 28% of the reserve, while the top three held approximately 58% and the top twenty approximately 92%. Eighteen of those top twenty positions borrowed USDC against NVDAc, in some cases alongside other tokenized equities, with health factors between 1.27 and 2.33 and a median of 1.55.

For METAc, the largest position accounted for approximately 27% of the reserve, the top three approximately 53% and the top twenty approximately 99%, LlamaRisk says. Nineteen of the top twenty borrowed USDC against METAc, sometimes alongside other tokenized equities; their health factors ranged from 1.16 to 2.60, with a median of 1.41.

Implementation process

The post says the updates will move forward through the Risk Steward process. It identifies LlamaRisk as an independent DeFi risk service provider funded in part by the Aave DAO and says the review was not compensated by the protocols or affiliated entities it assessed.

Sources

  1. Original source Aave Governance Forum governance.aave.com

Companies in this story

Related stories

Explore

More articles